5085712
Published: 6th May, 2010
Last edited: 12th May, 2010
Created: 11th July, 2009
This has been in the making for quite some time and I was only able to work on it because of the new fontstruct features. all bricks i used for this fontstructions were half-sized bricks. i mean half-circles, half-sized blocks and so on. also i worked with 1.75 scaling. thanks to this kind of setup i was able to create roundings, that go a little over or below flat-shaped letters. see the sample. also lower case letter like l, k, h and so on are a little taller than upper case letters, like in "real" fonts.
the disadvantage is seen on M,W,m,w where the stem in the middle is a little too short... i had to use a very weird workaround for these 3-stem letters, so this is as good as it gets, unless fontstruct is going to have an empty space brick, that would allow me to create a fitting composite. i used lots of composites and lots of stacking. also the spacing isn't very nice, i'll see if i can do anything about that.