Inspired by Briem Script.

I am very proud and happy that I have been awarded a staff pick starfish. ⭐️

Arabic is basic, only Arabic, Urdu and Persian are supported. Alternate samvat forms for 2, 3, and 5 digit years are in PUA. If you wanna remove the notch in U+16AEC, then use U+E000.

Only lowercase Georgian mkhedruli is supported.

Currenty working on Quranic annotation symbols.

My ratings dropped from 9.10 to 8.57??? omg these trolls are ANNOYING

( it is now 9.15 so yay :) thx ACSFM )

@AFontAbove No, this is Patrick.

Private Use Area (E000 ~ EFFF) contains all kinds of (existing) Latin characters that could normally only be made by using the combining diacritical marks.

This is another clone of Monkey (my monospace lanky font); it should be very similar to the original except for the lower x-height and the added accented characters (More Latin/Latin-1, Latin Extended A, Latin Extended B, and now Even More Latin/Latin Extended Additional). It is 16 blocks tall and 6 blocks wide; all letters without diacritics are at most 9 above the baseline and at most 3 below, but the accents push the height of a letter up by 3 blocks (or rarely 4), and the box drawing characters extend even higher, to 16 blocks from descender to the highest point. This font uses the FontStruct 2x2 filter method with plenty of composite and stacked bricks, which lets the curves look good at large sizes while remaining sharp on the screen at normal sizes. Mandrill will look strange in the FontStruct preview if you zoom in or out, but if you download it, it will look sharp at size 16 or 12 (depending on the program).

All cap bold serif

kerned : Russian, Latin Basic, More Latin

I can't even type cyrillic extended, there are too many letters in latin extended, I don't have greek keyboard either

I wish I could make everything, but I'm a human after all (or am I?), I decided that this is good enough

This font is designed to look alike Soviet typewriter font. A similar font was used by early-90's Russian-developed word processor, 'Lexicon' by Eugene Veselov.

A font i have been working on for a while, but with some characters removed, because it seemed like it was not going to be finished in a while. I just wanted to publish this first

An angular font with built-in ligatures for <f> and <j>. More punctuation and international support (hopefully) coming soon.